Campbell-scientific CR1000 Measurement and Control System Manual do Utilizador descarregar pdf (Página 488)

100

101

Appendix A. CRBasic Programming Instructions

488



CS110Shutter

ControlstheshutterofaCS110electric‐fieldmeter.

Syntax

CS110Shutter(Status, Move)

CS616

EnablesandmeasuresaCS616watercontentreflectometer.

Syntax

CS616(Dest, Reps, SEChan, Port, MeasPerPort, Mult, Offset)

CS7500

CommunicateswiththeCS7500open‐pathCO

andH

Osensor.

Syntax

CS7500(Dest, Reps, SDMAddress, Command)

CSAT3

CommunicateswiththeCSAT3three‐dimensionalsonicanemometer.

Syntax

CSAT3(Dest, Reps, SDMAddress, CSAT3Cmd, CSAT3Opt)

EC100

CommunicateswiththeEC150OpenPathandEC155ClosedPathIRGas

AnalyzersviaSDM.

Syntax

EC100(Dest, SDMAddress, EC100Cmd)

EC100Configure

ConfigurestheEC150OpenPathandEC155ClosedPathIRGasAnalyzers.

Syntax

EC100Configure(Result, SDMAddress, ConfigCmd, DestSource)

GPS

UsedwithaGPSdevicetokeeptheCR1000clockcorrectorprovideother

informationfromtheGPSsuchaslocationandspeed.Properoperationofthis

instructionmayrequireafactoryupgradeofon‐boardmemory.

Syntax

GPS(GPS_Array, ComPort, TimeOffsetSec, MaxErrorMsec,

NMEA_Sentences)

Note To change from the GPS default baud rate of 38400, specify the new baud

rate in the SerialOpen() instruction.

HydraProbe

ReadstheStevensVitelSDI‐12HydraProbesensor.

Syntax

HydraProbe(Dest, SourceVolts, ProbeType, SoilType)

LI7200

CommunicateswiththeLI7200openpathCO

andH

Osensor.

Syntax

LI7200(Dest, Reps, SDMAddress, Command)

1 2 ... 483 484 485 486 487 488 489 490 491 492 493 ... 587 588

Comentários a estes Manuais

Sem comentários

Campbell-scientific CR1000 Measurement and Control System Manual do Utilizador Página 488

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Campbell-scientific CR1000 Measurement and Control System