Campbell-scientific EnviroSCAN Sentek Water Content Profile Probe Manual do Utilizador descarregar pdf (Página 24)

Appendix A. Probe Assembly

FIGURE A-16. Location of Jumpers 1..16

After positioning and securing each sensor in its proper location, install the

jumpers on the ribbon cable boards. Begin at the main board end and install the

jumpers on each sensor board in numeric sequence as shown in Figure A-12.

Locate the sensor jumper pins as shown in Figure A-13. Set sensor 1 jumper to

the first position as shown in Figure A-14. Set sensor 2 jumper to the second

position as shown in Figure A-15. Set subsequent jumpers as indicated in Figure

A-16. The position of the jumper on the header and the location of the sensor on

the rail are NOT related and may or may not be the same.

A-6

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Sem comentários

Campbell-scientific EnviroSCAN Sentek Water Content Profile Probe Manual do Utilizador Página 24