Campbell-scientific Solar1000 Station Manual do Utilizador descarregar pdf (Página 19)

CM106 Tripod

Remove the washers, nuts and U-bolt from the U-bolt bracket. Install the

bracket as shown in Figure 1.5-12 (top). Tighten the nuts on the U-bolt until the

lock washers are compressed.

Route the 14 AWG wire from the grounding lug on the bottom side of the

enclosure to the grounding lug on the base of the tripod (Figure 1.5-8). Strip 1/2”

of insulation from each end of the wire. Insert wire ends into the grounding

lugs and tighten.

U-Bolt Bracket

Screw Head

Enclosure Tab

FIGURE 1.5-12. Enclosure with the –LM Bracket

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 64 65

Sem comentários

Campbell-scientific Solar1000 Station Manual do Utilizador Página 19