Campbell-scientific 020C Wind Direction Sensor Manual do Utilizador descarregar pdf (Página 15)

Model 020C Wind Direction Sensor

Alignment

set screw

CM220 mounting

bracket

Bushing

CM200-series

crossarm

FIGURE 7-1. 020C mounted with CM200-series crossarm and CM220

right-angle mounting bracket

FIGURE 7-2. 020C mounted with CM200-series crossarm and 1049

Nurail

fitting

7.4 Wiring

Attach the sensor cable to the six-pin male connector on the 020C. Make sure

the connector is properly keyed. Finger-tighten the knurled ring. Route the

sensor cable along the underside of the crossarm to the tower, down the tower,

and to the instrument enclosure. Secure the cable to the crossarm and tower

using cable ties.

The cable consists of five wires. Wiring for specific Campbell Scientific

dataloggers is shown in Table 7-1.

Alignment screw

CM200-series

crossarm

Bushing

1 x 3/4 N

fitting

urail

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Sem comentários

Campbell-scientific 020C Wind Direction Sensor Manual do Utilizador Página 15