Campbell-scientific SDM-INT8 8-Channel Interval Timer Manual do Utilizador descarregar pdf (Página 33)

Appendix A. Address Jumper

The address is factory set at address 00. Figure A1 (also shown inside the

INT8 cover) shows the 16 possible positions and their corresponding address.

Use the addresses shown in Figure A1 in Instruction 101.

The address block requires soldering to change the address. If two or more

INT8s are to be used on the same datalogger, one can remain at address 00,

while the others must be changed. Disconnect power before opening the case

and soldering.

Every SDM device connected to the datalogger must have a unique address.

Figure A-1. Address Selection

A-1

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

Sem comentários

Campbell-scientific SDM-INT8 8-Channel Interval Timer Manual do Utilizador Página 33